Brake Adjustment - Brigmton BMi-365-B-N Manual De Instrucciones

5. Learning and safety: A learning process is necessary for the use of this
device. Just as the process of learning to drive a bicycle or a motorcycle
requires practice, the use of the electric scooter needs practice before
making movements, turns or raising speed. A use of it without a correct
learning process can cause injuries. Use protections to prevent damage.
Once you complete these steps you can turn on the skate:

BRAKE ADJUSTMENT

If you feel the brakes are too tight, use the hex wrench counterclockwise to
loosen the screws on the pressure plate on the disc brake seat, release the
brake line to shorten slightly the exposed length and tighten the screws of
the pressure plate. If you feel that the brake is too loose, release the screws
on the pressure plate, drag the brake cable to slightly lengthen the length
and then lock the screws on the pressure
plate.
BAR ADJUSTMENT
If you feel that the bar is not tight enough, use the hex wrench to tighten
the two screws in the folding mechanism.
INFLATION OF WHEELS
If you notice that you need more air pressure in the wheels, use an inflation
system to adjust the pressure. CAUTION: Excessive pressure could cause the
wheel to burst.