MUNDO CLIMA MUPR-H7 Manual De Instalación Y Usuario página 123

1 ON/OFF
2
MODE
TEMP
3
FAN
4
SLEEP
TURBO SELF CLEAN
5
6
RG57A6/BGEF
13
12
SILENCE
FP
11
TIMER
ON
TIMER 10
OFF
9
SWING DIRECT
8
LED FOLLOW ME
7
123
9
SWING Button
Used to stop or start horizontal louver auto
swing feature.
DIRECT Button
Used to change the louver movement and set
the desired up/down air flow direction.
The louver changes 6 in angle for each press.
NOTE: When the louver swing or move to a
position which would affect the cooling
or heating effect of the air conditioner,
it would automatically change the
swing/moving direction.
10
TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the auto
-timed setting in 30 minutes increments.
When the setting time displays 10.0, each
press will increase the auto-timed setting
60 minutes increments. To cancel the auto-
timed program, simply adjust the auto-off
time to 0.0.
11 TIMER ON Button
Press this button to initiate the auto-on
time sequence. Each press will increase
the auto-timed setting in 30 minutes
increments. When the setting time displays
10.0, each press will increase the auto-
timed setting 60 minutes increments.
To cancel the auto-timed program, simply
adjust the auto-on time to 0.0.
12 SILENCE/FP Button
Active/Disable SILENCE function.
If pushing more than 2 secons the "FP"
function will be activated, pushing more
than 2 seconds again to disable.
When the Silence function is activated, the
compressor will operate at low frequency
and the indoor unit will bring faint breeze,
which will reduce the noise to the lowest
level and creat a quiet and comfortable room
for you. Due to low frequency operation of
compressor, it may result in insufficient
cooling and heating capacity.
,
,
The FP function can only be activated
during the heating operation (only when the
setting mode is HEAT). The unit will operate
at a setting temperature of 8 C.The display
window of indoor unit will display FP . Press
the buttons of ON/OFF, SLEEP, FP, MODE,
FAN SPEED,UP or DOWN while operating
,
,
will cancel the FP function.
13 UP Button ( )
Push this button to increase the indoor
temperature setting in 1 C increments to 30 C.
DOWN Button (
Push this button to decrease the indoor
temperature setting in 1 C increments to 17 C.
NOTE：Temperature contol is not available
in Fan mode.
O
O
,
,
o o
)
o o