Nowsonic AUTARK DS512 Manual Del Usuario página 8

Nowsonic Autark DS512
GB
User manual
NOTE: When supplying the device via the
make sure that the assignment of the power supply unit corre-
sponds in any case with the requirements of the Autark
since the transmitter could be damaged otherwise.
Please note: If the Autark
DC 12V IN
socket, the power supply is also available at the
CON OUT socket and can be tapped there.
3. Safety ring
In combination with an optional lock, you can secure the Autark
against theft with this metal ring.
4. Earthing point
This screw allows to connect external devices with the ground of the
Autark .
DS512
5. sockets
DMX OUT / DMX IN
You can connect the Autark
vices through these sockets. The connectors in the
hereby serve for feeding in the
controller (e.g. the Nowsonic Autark
compatibility, the Autark
following standards:
DC 12V IN
is being supplied with power via the
DS512
with external
DS512 DMX
DMX IN
source signal: connect a
DMX
LED Master II ) here. For maximum
offers connectors according to the
DS512
socket, 45
DMX RJ
d d
5-pin
DMX
d d
, 3-pin (standard)
DS512 DMX
d d
Wiring
RJ 45
POWER-
Pin 1: ground (shield)
Pin 2: ground (shield)
Pin 3: not used
Pin 4: signal inverted, DMX -
DS512
Pin 5: signal, DMX+
Via the sockets in the
signal and loop it through to local external
of the input socket through which you control the Autark
control signal is always available on all output sockets.
DMX
-capable de-
section
DMX
8
www.nowsonic.com
XLR 5-pin XLR 3-pin
ground (shield) ground (shield)
signal inverted, DMX - signal inverted, DMX -
signal, DMX+ signal, DMX+
Data - -
Data + -
DMX OUT section you can tap the
devices. Regardless
DMX
control
DMX
, the
DS512