Nowsonic AUTARK LED MASTER II Manual Del Usuario página 12

Nowsonic Autark LED Master II
GB
User manual
STROBE mode
The Strobe mode is activated by pressing and holding the
button. When you hold the
effect can be set with the
to 20Hz.
STROBE
When the button is released, the
previous mode.
Regardless of the current mode, you can press the
at any time to temporarily darken all connected lights for the duration
of the button press.
STROBE
button, the speed of the Strobe
STROBE SPEED
fader in the range from 1
LED Master II
BLACK OUT
Specifications
STROBE
Type
Data format
protocol
DMX
DMX channels
returns to the Channel modes
DR GB W
Operating voltage
button
connector
DMX
Weight
Dimensions
Scope of supply
Autark
LED
d d
Wall power supply: 1 pc
d d
User manual: 1 pc
d d
Disclaimer
Nowsonic has taken all possible steps to ensure that the information
given here is both correct and complete.
In no event can Nowsonic accept any liability or responsibility for any
loss or damage to the owner of the equipment, any third party, or any
equipment which may result from use of this manual or the equip-
ment which it describes.
12
controller
DMX
DMX
DMX 512
40
R GB , R GBD , R GB W
9–12 VDC 300 mA (external power supply
included)
3-pin (output)
XLR
0.8 kg
200 × 56 × 110 mm (H × W × D)
Master : 1 pc
II
www.nowsonic.com
, R GB WD , DR GB ,