Black Out - Nowsonic AUTARK LED MASTER II Manual Del Usuario

www.nowsonic.com
6. 1–10, 11–20, 21–30 and 31–40 buttons
Using the 1–10, 11–20, 21–30 and 31–40 buttons you can choose
the desired channel group which is then controlled via the
W/D
faders: thus, 40 channels in total can be controlled. The
to the buttons show the current selection.
7. button
CHANNEL MODE
You can choose the desired channel mode for the faders
W/D CHANNEL MODE
and via the
is shown via the s above the buttons. You can choose from the
LED
following six modes:
LED Channel mode Mode description
M1 Channel 1 = red, channel 2 = green, channel 3 = blue
RGB
Channel 1 = red, channel 2 = green, channel 3 = blue,
M2 RGBD
channel 4 = dimmer
Channel 1 = red, channel 2 = green, channel 3 = blue,
M3
RGBW
channel 4 = white
Channel 1 = red, channel 2 = green, channel 3 = blue,
M4
RGBWD
channel 4 = white, channel 5 = dimmer
Channel 1 = dimmer, channel 2 = red, channel 3 =
M5
DRGB
green, channel 4 = blue
Channel 1 = dimmer, channel 2 = red, channel 3 =
M6 DRGBW
green, channel 4 = blue, channel 5 = white
R, G, B and
s next
LED
R, G, B
1
button ( ): the active selection
Nowsonic Autark LED Master II
8. button
RUN MODE
RUN MODE
By pressing the
program which you have selected via the
automatically or via the music sensitivity. Depending on the selection,
LED AUTO SOUND
the or lights.
9. button

BLACK OUT

Press the BLACK OUT button to set all channel values temporarily to
0: this means that all controlled slave units are idle (not lit) as long as
you hold this button pressed.
10. button
STROBE
Press this button to activate the Strobe mode: the Strobe effect is
active as long as you hold the button pressed. When the Strobe mode
is active, you can control the Strobe speed via the
Sensitivity fader (
5 ) in the range from 1 to 20Hz.
Cabling
The Master allows to control external slave devices via up to 40
LED II
channels. Connect the devices as follows:
1)
Using the supplied wall power supply, connect the
to the mains power and switch the unit on.
2)
Connect a standard high quality
to the out socket (female) of the
DMX
9
User manual
button you can choose whether the
MAC fader ( 3 ) is controlled
STROBE SPEED
LED Master
audio cable (not supplied)
XLR
Master .
LED II
GB
/
II