Weidmuller MCP BASIC 2 Manual De Instrucciones página 28

Commissioning
5.4 Loading the plotter
We recommend preparing the mounting
plates off the plotter and placing them in
the plotter before the plotter is switched
on. This allows you to be certain that the
auto-calibration process is effective, even
when the writing arm is moved during the
loading process.
► Fit the adjuster plate into the mounting plate as
shown in the software (specification position 1 to
5, position 6 means no adjuster plate).
1
2
3
4
5
6= without this inlay
Fig. 5.2 Positioning the adjuster plate (here: position 3)
► Place the labelling elements on the adjuster plate.
► Place the fully loaded mounting plate flush to the
left on the base plate of the plotter so it is held by
the holding pins.
28
1168680000/02/12.2016