Installing The Battery; Removing The Battery - König Electronic KN-LED60 Manual De Uso

Installing the battery

To install the battery on the KN-LED60 light, place the battery into the tray just in front of the contacts
and push forward. A "click" will tell indicate it is locked into place. Fully charged, it should last about
1.5 hours.
Press the thumb catch and slide the battery backwards

Removing the battery

To remove the battery press the thumb catches on the unit at the rear of the battery and push back
about 0.25 inches. The battery is now loose and will come apart from the body of the KN-LED60.
Locking adapter
Using the locking adapter
The locking adapter is required when you are using the side bracket or attaching it directly to your
camera's accessory shoe.
On the KN-LED60, locate one of the two "female" receptacles that will accept the locking adapter's
silver foot. One will be for "vertical" and one for "horizontal" use.
Slide the silver plate of the locking adapter into the receptacle on the light. Then tighten down the top
knurled ring until the locking adapter is snug on the light. Do not over-tighten!
Mounted on camera shoe
The other foot of the locking adapter has a standard accessory foot, and also 1/4 x 20 threads. If the
light is to be mounted onto a camera, simply slide the locking adapter onto the accessory shoe and
tighten down the knurled ring until the light is snug. Do not over-tighten!
3