Quick Set-Up Guide; Detailed Set-Up Guide; Battery Installation - La Crosse Technology WT-5120 Instrucciones De Uso

Daylight Saving Time changes. After the top of the minute, a tone will sound for every second. It is
possible that your projection alarm may not be exactly on the second due to the variance in the
quartz. However, the clock will adjust the quartz timing over the course of several days to be very
accurate; under 0.10 seconds per day.

QUICK SET-UP GUIDE

Hint : Use good quality Alkaline Batteries and avoid rechargeable batteries.
1. Have the projection alarm and remote temperature sensor 3 to 5 apart.
2. Batteries should be out of both units for 10 minutes.
3. Place the batteries into the remote temperature sensor first then into the projection alarm.
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the display and sensor will start to talk to each other and the display will show both the
indoor temperature/humidity and an outdoor temperature. If the station does not display both
temperatures and indoor humidity after the 15 minutes please retry the set up as stated above.
After both indoor and outdoor temperatures are displayed for 15 minutes you can place your sen-
GB
P.6
up problems make sure that they do not spring free during installation).
3. Replace the battery cover.
B. PROJECTION ALARM
1. Remove the battery cover.
2. Observe the correct polarity, and install 2 AA batteries.
3. In addition or instead of inserting batteries, the AC adapter can be used. Simply plug the adapter
into the receptacle on the underneath of the alarm clock and then plug in adapter.
GB
P.8
sor outdoors and set your time.
The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80
feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or
window will have up to 20 feet of resistance and an interior wall will have up to 10 feet of resistance.
Your distance plus resistance should not exceed 80 ft. in a straight line.
NOTE : Fog and mist will not harm your remote sensor but direct rain must be avoided.
To complete the set up of your temperature station after the 15 minutes have passed please follow
the steps beginning on page 11.

DETAILED SET-UP GUIDE

II. BATTERY INSTALLATION
A. REMOTE TEMPERATURE TRANSMITTER
1. Remove the battery cover.
2. Observing the correct polarity, install 2 AA batteries. The batteries will fit tightly (to avoid start-
4. Replace the battery cover.
5. The projector will activate and remain on if the alarm clock is plugged in. If only batteries are
used, the projector will only be activated when a button is pressed. The projection is a red light,
not harmful under normal usage, although care should be taken to not look directly into the
light.
Notes:
• After the batteries have been installed a tone will sound, and the LCD (Liquid Crystal Display)
will activate.
GB
P.7
AC adapter receptacle
GB
P.9