Program Mode; Programming Sequence; Function Buttons; Manual Time Setting - La Crosse Technology WT-5120 Instrucciones De Uso

• The indoor temperature/humidity and the remote temperature will be displayed. Also, the time
will appear as "-:—".
• The WWVB search is automatically initiated, and a tower icon appears and flashes with the
time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time
display will remain on "-:—").
• While the WWVB search is being conducted various numbers will appear in the time display.
• After 15 minutes, the projection alarm will either display the WWVB time, or discontinue the
search if the time is not found. If the search is cancelled "-:—" will remain in the time LCD.
• The projection alarm will conduct a WWVB search every hour until the first signal is found.
• Once the WWVB time is found, a search is automatically conducted nightly at midnight.
• If the signal is found at midnight, the tower icon will remain, if not, another search will take place
every hour (until 6:00 am) until the signal is found successfully.
• If no signal is found during this period, the tower icon will not appear and the clock will search
again at 12:00 am the next night.
• The radio-controlled time receiver is located on the bottom side of the projection alarm. When
using the AC adaptor be sure to keep the adapter cord away from the bottom side of the unit as
if the wire is too close it can cause weakened reception sensitivity.
GB
P.10
B. FUNCTION BUTTONS
There are 3 function buttons located on the front of the projection alarm and one on the top. The
function buttons are labeled: ALM/HOUR, light direction icon, SET/SEL/MIN, and SNOOZE/
ADVANCE (the top bar).
Alarm Button (also adjusts the Display Direction
hours in time setting mode)
C. MANUAL TIME SETTING
1. Hold down the "SET/SEL/MIN" button for 3 seconds, the time will flash in the Time LCD.
GB
P.12
III. PROGRAM MODE
To enter the Program Mode hold down the "SET/SEL/MIN" button for 3 seconds, until the time
flashes in the top of the display. The Program Mode Guide is laid out in a manner that allows you
to program each function separately, or you can follow the instructions entirely to program the
projection alarm. Complete programming is usually done for the initial set-up, and will require you
to skip step 1 and 2 of programming sections D and E. To exit the setting mode simply wait
approximately 10 seconds for the projection alarm to automatically return to normal operation.
A. PROGRAMMING SEQUENCE
1. Manual Time Display

2. Time Zone Setting

3. Daylight Saving Time On/Off
2. Press and release the "ALM/HOUR" button to advance the hours and press and release the
/ NOTE: "A.M." or "P.M." will be displayed to the left of the time to help identify the time.
3. Press and release the "SNOOZE" button to confirm the time setting and to advance to DST
D. TIME ZONE SETTING
1. Hold down the "SET/SEL/MIN" button for 3 seconds, the time will flash in the Time LCD.
2. Press and release the "SNOOZE" button to advance to the time zone selection.
3. In the indoor temperature/humidity section of the LCD the time zone will flash.
4. Press and release the "SET/SEL/MIN" button to select the appropriate time zone. There are 24
Mode Button (toggles between indoor
temp/hum and alarm time . Also
adjusts minutes in time setting mode.)
NOTE:
indicator. For example Eastern Time will display "ET" when the Eastern Time Zone is selected
"SET/SEL/MIN" button to advance the minutes.
(Daylight Saving Time) setting.
time zones to choose from (based relative to the international time standard of GMT ("Greenwich
Mean Time).
The U.S. time zones will show abbreviations as opposed to the numerical time zone
GB
P.11
GB
P.13