Problem
The product
does not oper-
ate when push-
ing the switch
to ON.
Water does not
discharge
properly or, no
water discharg-
es
from the wand,
even though
the
device is ON.
Water leaks
from the tank.
Water leaks
from the wand
after
use.
* Repair of this product requires the expertise of a trained technician. Do not attempt to
repair a malfunctioning product without consulting a Service Center.
SPECIFICATIONS
Dimensions
(main unit)
Total product weight
Discharged water
volume
Tank capacity
Power source
Battery life (at 20°C)
Accessories included Carrying pouch (1), AA alkaline battery (1)
TROUBLESHOOTING
Possible Cause
The battery has been
inserted incorrectly.
The battery needs
replacing
A manganese battery has
been installed instead of
an alkaline battery.
The battery needs
replacing
The wand is clogged up.
The strainer inside the
tank is clogged up.
The tank has not been
pulled out all the way.
The wand has not been
stored properly into the
storage position.
When stored: 2.65" x 1.8" x 5.1" (67 x 46 x 130mm)
When in use: 2.65" x 1.8" x 11.7" (67 x 46 x 298mm)
Approximately 0.55 lbs (250g) (including the battery)
Standard: 0.28 Ounce/sec (8ml/sec) (when the alkaline battery
is new)
Soft: 0.32 Ounce/sec (9ml/sec) (when the alkaline battery is
new)
0.19 Quarts (180ml)
1 AA alkaline battery
Approximately 50 applications (for use with an alkaline bat-
tery with up to 0.17 Oz/Sec (5ml/sec) of discharged water
volume).
Solution
Reinsert the battery, making sure it is
correctly positioned in the +/- posi-
tion.
Insert a new battery into the
battery encasement.
Replace the battery with an
alkaline battery.
Insert a new battery into the
battery encasement.
Clean the wand
Clean the strainer
Pull the tank out all the way until it
clicks into place.
Check to make sure the
protruded end of the wand has
been inserted into the hole on the
main unit and has been folded in
the direction of the arrow for proper
storage.
8