Publicidad
DESCRIPTION
A A A A A
(starts at page 35
1
Handles
2
Accelerator
3
Dash-board
4
Rod
B B B B B
ASSEMBLY (
starts at page 35
OPERATION (
starts at page 36
C C C C C
Before you start working, make sure to remove any objects or obstacles that may have been left on the lawn. The operator is responsible for the safety of other people in
the working area.
(starts at page 36)
D D D D D
Once the machine has been set up properly, start the engine as follows:
a) Engines with choke system:
if the model is equipped with an accelerator, when the engine is cold, position the accelerator lever (2-Fig.E) on START
Engines with primer system:
Press the fuel-enrichment pump located on the carburettor 3 or 4 times.if the model is equipped with an accelerator, position the accelerator lever (2-Fig.E) on MAX.
(starts at page 36)
E E E E E
b) Grip the engine start grip (10) and pull the starter rope gently until you feel the resistance caused by compression. Release the handle; then give the starter rope a sharp
tug.
For further information and explanations, read carefully the user instruction manual of the engine.
(starts at page 36)
F F F F F
Before starting work, it is necessary to carry out the following:
- set the trasport wheels (5) upwards.
(starts at page 36)
G G G G G
Initially position the hook (15) of the forward drive cable and the hook (16) of the reverse clutch cable in the holes (II°) of the respective handles (12-13).
Should the handle action not follow the cutter clutch, position the hook into hole (I°) of the handle, while on the contrary insert it into hole (III°) should the cutters remain
engaged even on release of the handle itself.
(starts at page 36)
H H H H H
WARNING ! Never keep the two handles (12-13) activated at the same time. It may cause damage to the belts and pulleys.
(starts at page 36)
I I I I I
WHEN THE TILLER IS ON: in order to make the tiller blades (6) run, handle (12) must be depressed. When working with the tiller, keep the handle depressed. If the handle
is released, the tiller blades will come to a stop.
Depress the skid in order to work in depth and decrease the pressure to move forwards.
(starts at page 36)
L L L L L
REVERSE-GEAR: for engaging the reverse-gear, only handle (13) must be actuated.
How to stop the engine: for this purpose, shift the accelerated lever into STOP position.
(starts at page 36)
M M M M M
The four cutter stars (6) can be pulled off, and the combination of cutters allows working widths from 25 to 55 cms.
For assembly, introduce the blade star (6) to the rotary shaft (N) and make the two holes (P) match: then introduce pin (R) by fastening it with the respective spring. Make
sure that the hoeing blades are assembled in the right direction, i.e. the cutting angle showing forward.
)
5
Transport wheels
6
Hoeing blades
7
Protection guard
8
Fuel tank
)
)
9
Spark plug
10
Engine startgrip
11
Reduction gear
12
Clutch lever
7
ENGLAND
13
Reverse lever
14
Side disk
Publicidad
