Belt Change Or Tightened; Engine´s Maintenance - INDUSTRIAS TECHNOFLEX MAMUT 20 Manual De Instrucciones

1B
OPERATION
1.9

Belt Change or Tightened

1 Remove the belt protections.
2 To loose the 4 nuts pos. A. of the base engine
3 Change belt type BX-32 if necessary.
4 Push the motor in the direction of the arrow until the belt reaches the required voltage and tighten
the 4 nuts on the post. A .
5 Mount protections.
1.10 Engine´s Maintenance
The engine is an element that requires little maintenance, only it is necessary to have a minimum of
care in the cleaning and therefore it is necessary to clean the air filter every 150 working hours.
If the engine does not start, the causes can be the following ones:
CAUSE
No fuel in tank
Fuel faucet is closed
Defect in the recoil starter
No oil alert
Engine switch in position OFF
1B-7
SOLUTION
Fill fuel
Open
Repair or replace
Fill oil to the level
Turn to position ON
ENGLISH