Benassi BL 6000 Manual De Uso página 44

For the usual engine servicing (oil, filter, spark plug and adjustments) read the engine manual delivered with the
machine.
• It is necessary to check periodically the oil level in the gearbox by at least every 50 working hours. If necessary add
MPS SAE 80/90 oil.
• The oil has to be changed every 200 working hours. Unscrew the cap (Ref. "B" Pict.10), drain out all the oil letting
the cap (Ref. "A" Pict.10) open. Then put back the cap (Ref. "B" Pict.19) and top up with oil (about 1,3 litres).
• The frame has waterproof ball bearings. The transmission in the frame is engaged by two normal grease-lubricated
chains.
• All the joints, the cables and the tightener support bolt should be oiled from time to time.
• Keep the machine and the blades clean. Check periodically, at least once a year, that all the screws and nuts are well
tied, especially the screws of the tiller (always wear protection gloves while working on the tiller).
• In case of breaking or wear of the belt, you can replace it after taking off the side protection cover by unscrewing 2
knobs fixing the side protection cover (Pict. 11 Ref. "A").
• Take off the belt from the pulleys and install the new belt. After replacing the belt, adjust it to the correct tension
following the instructions in the chapter "CLUTCH BELT", then reassemble the cover again.
For any technical repair especially during the guarantee period, it is suggested to apply to the specialised workshops of
our dealers.
CLUTCH BELT
Clutch belt adjustment (see picture 12)
Remove the cover by unscrewing both fastening screws, a second operator will pull the clutch lever (A). Verify that the
belt (C) has got a max distance of 2,7 cm and if it doesn't happen proceed as follows:
g. adjust the belt tension by regulating the clutch lever (A) through the adjusting screw (B) on the left handlebar;
h. if the belt distance (C) is still out of the mentioned tolerance, loosen the four bolts (D) clamping the engine and shift
the engine (E) forwards till you get the right values.
Clutch belt replacement (see picture 12)
a. loosen the adjusting screw (B) on the left handlebar and extract the belt from the pulleys.
b. Install the new belt on the pulleys verifying that the max. distance is about 2,7 cm and that the clutch lever doesn't
have any clearance otherwise carry out the adjustment described before.
Our machines and accessories are guaranteed for 2 years excluding electric and rubber parts.
All the defective parts will be replaced free of charge excluding cost of labour and transport freight, which would be at
customer's charge.
For any problem regarding the engine or any other part not of our production, please refer to the guarantee conditions
stated by the manufacturer and apply to their assistance centres.
For any kind of problem or repair please apply to the dealer where you bought the machine.
SERVICING
WARRANTY
44
BL 6000