Connecting The Device To A Computer Or Computer Network; Switching The Device On And Off; Operation; Inserting Consumable Material On Rolls - HellermannTyton TT4030 Manual De Instrucciones

5 .3 Connecting the device to a computer or
computer network
NOTE
Material damage caused by improper work!
Inadequate or no grounding of the components can cause
malfunctions during operation.
f Only connect the device to a properly installed and
standardised socket with grounding.
Proceed as follows:
1 Connect the device to a computer or computer network.
Æ Configuration instructions
; The device is connected to a computer or computer
network.

5 .4 Switching the device on and off

Proceed as follows:
1 Ensure that all connections have been made.
2 Switch the device on using the power switch.
; The device automatically performs a system test and
shows the system status READY on the display.
- or -
3 Rectify error, if applicable.
Æ Section 8

6 Operation

f For settings and simple assemblies, use the supplied
Allen key located in the upper part of the print
mechanism. Other tools are not required for the work
described in the following.

6 .1 Inserting consumable material on rolls

6 .1 .1 Positioning the material roll on the roll holder

10
9
Insert the roll material.
1 Margin stops
2 Ring
3 Material roll
4 Roll holder
5 Internal winder (only included with the dispenser version)
6 Guide
7 Knurled knob
8 Light barrier
9 Printhead locking lever
10 Cover
1 Open the cover.
2 Turn the ring counterclockwise, so that the arrow points
to the
3 Remove the margin stop from the roll holder.
4 Load the material roll onto the roll holder so that the
printed side of the material faces up.
5 Push the margin stop onto the roll holder.
6 Push the margin stops until both margin stops rest
against the material roll and noticeable resistance can be
felt when pushing.
7 Turn the ring clockwise, so that the arrow points to the
symbol and the margin stop clamps onto the roll
holder.
8 Unwind the consumable material.
For dispensing or winding mode: ca. 60 cm
For tear-off mode: ca. 40 cm
; The material roll is positioned on the roll holder.
Operating Instructions • Thermal Transfer Printer TT4030 • 06-2017 • 031-93478
symbol and the margin stop is released.
Operation
1
2
3
4
5
11