PowerWalker VI 600 SW Guia De Inicio Rapido página 7

NEVER connect a laser printer or scanner to the
UPS unit, because in-rush current generated by
motor's devices may cause the damage of the unit.
VI: Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the
power switch.
6. Audible alarm from the UPS

When UPS switches from AC mode to Battery Mode to back up power supply: sounding
every 10 seconds

When battery is low: sounding every second

When UPS is overloaded: sounding every 0.5 second

When battery is faulty: sounding every 2 seconds

Other fault: Continuous sounding
7. Software Installation on your PC

Use the bundled CD and follow the on-screen instructions to install the software
ViewPower.

After the software is successfully installed, the communication with UPS has been
established and an orange icon will appear in the system tray.

Double-click the icon to use the monitor (as above).

You can schedule UPS shutdown/start-up and monitor UPS status through PC.

Detail instructions please refer to the e-manual in the software.
EN