Attaching The Marine Case To The Camera - JVC WR-MG270 Manual De Instrucciones

Attaching the Marine Case to the
Camera
A
Setup the camera.
For models equipped with light, turn off the
light.
Open the lens cover.
Set to the shooting mode (video/still
image).
Even when the shooting mode is set to
"video", still images can be captured by
pressing the still image lever during video
recording.
It is recommended to set to the auto
shooting mode.
Insert the battery and the microSD/
microSDHC card or SD/SDHC card
beforehand if needed.
To turn off the camera, press and hold the
power button for more than 2 seconds.
B
Insert the drying agent at the back of the
base.
2 Catch
1
Pass underneath
C
Attach the base to the bottom of the
camera.
Align the tripod screw hole at the bottom of
your camera with the screw of the base,
and tighten the screw.
Tighten the screw
2
1
Caution
The camera turns on automatically when the
LCD monitor is opened. To turn off the camera,
press and hold the power button for more than
2 seconds.
Drying agent
Open up the LCD monitor
D
Fold the grip belt.
Make sure the grip belt is not caught
between the marine case when sealing.
E
Open the marine case.
If it is difficult to open buckles, use the
small hexagonal wrench (buckle opener).
Small hexagonal wrench
(Buckle opener)
F
Attach the power button cap.
(Not required for GZ-HM545 to GZ-HM570.)
Fit the hollow of the power button cap to
the protrusion of the power button on the
case.
G
Insert the camera into the marine case.
Align the base attachment groove with the
base to insert.
Base attachment groove
Base
Marine case internal base
H
Adjust the angle of the LCD monitor.
The LCD monitor can be tilt upwards to a
maximum angle of 30 degrees.
Power button cap
17