Hayward Tiger Shark RC9990CUB Manual Del Usuario página 11

Check the height of the waterline on TigerShark:
- Ensure that the filter is clean.
- Put the cleaner in the water and observe the height of the waterline on the cleaner. For this purpose,
let it perform several cleaning cycles in order to determine an average height.
- Once the waterline is settled, if the cleaner regularly makes excessive rattling noises, takes air in through
the bottom cover, climbs up the edge of the wall instead of going back the other way, or if it tends to stagnate
in the same zone of the pool, it is probable that TigerShark is climbing too high: install the reducer kit.
Optimum waterline height Incorrect waterline height
For the cleaner to operate properly...
The best water temperature for optimum operation of TigerShark lies in the range 10°C to 35°C. However,
TigerShark can be used in water at a different temperature.
Regular cleaning of the filter cartridge after use, every time the cleaner is used, optimizes performance of
the appliance. If TigerShark is struggling to climb up the walls of the pool, wash the filter and then resume
pool cleaning.
Replace the brushes (1) when they are worn to maintain effective cleaning.
If granulated chemical products are used on a daily basis in the pool, we recommend using a floating or
automatic metering feeder because such a feeder retains the calcium sediment that is sometimes contained
in that type of product.
It is recommended not to use TigerShark before all of the chemical powders are not dissolved because they
could clog the filter.
In a hard-water pool, more frequent cleaning of the filter is advised. Keep the TigerShark packaging for stor-
ing it or transporting it (in case any repairs are necessary).
The motor unit (13) and the power supply box (1) do not contain any parts that are of use to the user. If they
are opened the warranty automatically becomes NULL AND vOID.
TigerShark Quick Clean
1. For installation and normal use of TigerShark QC, please refer to the chapter on general use.
. In order to select the normal cycle or the economy cycle, please follow the following instructions: on
switching on, the economy programme is automatically selected. The "Quick Clean" light, situated on the
control box, then comes on. In this mode, TigerShark will switch off automatically after 90 minutes.
3. In order to select the normal programme, please press the "Full Cycle" button. The light situated above
the button comes on and indicates that the normal programme is running. In this mode, TigerShark will
switch off automatically after 3 hours.
If the economy mode is finished, you should switch off TigerShark and then switch it back on in
order to select normal mode: normal mode can be selected only during an economy cycle.
11