Dometic MAGICCOMFORT MSH60 Instrucciones De Montaje Y De Uso página 10

Safety and installation instructions
• Secure any parts of the system covered by the bodywork in such a
manner that they cannot be come loose or damage other parts and
cables or impair vehicle functions (steering, pedals, etc).
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may
only be performed by qualified specialists.
A
NOTICE!
• To prevent damage when drilling, make sure there is sufficient space
on the other side for the drill head to come out.
• Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
A
NOTICE!
• When testing the voltage in electrical cables, only use a diode test
lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too high and
which can damage the vehicle's electronic system.
• When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
• Insulate all connections.
• Secure the cables against mechanical wear with cable binders or insu-
lating tape, for example to existing cables.
Observe the following instructions when using the seat heater:
• Do not place any sharp or heavy objects on the seat, as the seat heater could
otherwise be damaged.
• Persons with an impaired sensitivity to heat should only operate the seat heater at
level I.
• Do not place any heat insulating objects, such as blankets or coats, on the seat
when the seat heater is switched on.
• The seat heater can be damaged by fluids spilt on the seat.
• Never switch the seat heater on when it is wet.
10
MSH60, MSH601
EN