Dometic MAGICCOMFORT MSH60 Instrucciones De Montaje Y De Uso página 13

MSH60, MSH601
• Soldering iron (14)
• Solder (15)
• Cable bushing sleeves (if necessary)
To fasten the cables you may require additional cable binders.
7.2 Installing the seat heater
The seat heater MagicComfort MSH60 includes heating elements for the driver's
and passenger seats; the seat heater MagicComfort MSH601 only includes heating
elements for the driver's or passenger seat.
Removing the seat
➤ Secure the vehicle against rolling away.
A
NOTICE!
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the upholstery.
➤ Check the suitability for installation using these installation instructions and the
manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
Preparing the seat
➤ Remove all plastic panelling from the seat to ensure the fastening of the cover
fabric can be reached.
➤ Separate the backrest from the seat (fig. 5, page 4 and fig. 6, page 4).
➤ Open the seat cover on the seat surface.
The cover fabric is usually tucked into a seam on the frame with a wide cardboard
strip or metal wire.
➤ Remove the fasteners using a screwdriver and pliers (fig. 7, page 4 and fig. 8,
page 5).
➤ Remove any upholstery staples or cross braces (fig. 9, page 5).
EN
Installing the seat heater
13