3M PPS Manual De Instrucciones página 3

To avoid risk associated with or exposure to hazardous liquids, which if not avoided, could result
in death or serious injury:
• Read, understand, and follow all safety information contained in these instructions prior to using the
3M™ PPS™ Type H/O Pressure Cup. Failure to follow all instructions could result in personal injury
or product damage. Retain these instructions for future reference.
• Always refer to the safe use recommendations from the spray gun manufacturer, the Safety Data
Sheet and the label of the material being sprayed.
• Always wear appropriate Personal Protective Equipment including eye, respiratory, and skin
protection.
To avoid the risk associated with hazardous pressure, which if not avoided, could result in minor
or moderate injury and/or property damage:
• Before each use, inspect the pressure regulator, 3M™ PPS™ Type H/O Pressure Cup, Retaining
Collar Shroud assembly and other pressure components for damage and ensure proper function
according to manufacturer's instructions.
• Be sure the supply pressure to the cup is controlled equal to or less than (≤) a maximum operating
pressure of 10 psi (69 kPa, 0.69 Bar).
• Do not allow paints, coatings or materials to dry or build up in the bottom of the cup. Hardened
materials may damage the built in pressure relief valve and/or result in loss of safety function.
• Never attempt to repair or block the built in pressure relief valve at the base of the 3M™ PPS™
Type H/O Pressure Cup; any such tampering of the cup may result in loss of safety function and will
void all warranties.
• Never attempt to block fl ow of air at the air cap of the spray gun while the unit is pressurized.
• Be sure to maintain spray gun equipment according to the manufacturer's instructions.
• Never allow the air cap to become obstructed with dried materials; periodically while spraying
inspect the spray gun air cap for buildup particularly when using highly viscous materials.
• Always follow the pressure relief / material bleed-back procedure for the pressure cup described in
steps 11 and 12 of the Directions For Use section of this manual.
• Always wear appropriate Personal Protective Equipment including eye, hearing and skin protection.
• Always refer to recommendations from the spray gun manufacturer and the Safety Data Sheet of the
material being sprayed.
• Always ensure the Shroud is engaged in the Retaining Collar prior to use.
• Always ensure that the Retaining Collar is properly seated and tightened prior to use.
• Always use 3M™ PPS™ Lids and Liners for proper operation. Substitute products may cause
unexpected failure.
This product has been designed and manufactured in accordance with sound engineering practice.
This product has been evaluated per Article 4, Paragraph 3 of the Pressure Equipment Directive 2014/68/
EU -Pressure Equipment.
WARNING
CAUTION
English - 2