Maintenance & Servicing - Bibby Sterilin Stuart SA7 Instrucciones De Funcionamiento

To select continuous mode, press the <mode>
button (the light will change to show continuous
mode). The unit will now remain on until either
the <mode> button is pressed to select touch
mode or the unit is switched OFF.
Accessory heads
N.B. Accessory heads are for use with model
SA8 only. Accessory heads should always be
used in the continuous mode.
To change the head, remove the rubber cup by
pulling upwards and store in a safe place. Insert
the accessory head ensuring that the two slots in
the head are in line with the lugs in the vortex
mixer top.
The microtitre plate holder (SA8/1) should not be
used at speeds above 800rpm.
Maintenance & Servicing
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
The following spares and accessories are available
from your laboratory dealer.
Description
Microtitre plate holder
Spare rubber cup
Retort rod, 300mm
For a comprehensive list of parts required by
service engineers conducting internal repairs and
a service manual, please contact the Technical
Service Department of Bibby Sterilin Ltd. quoting
both the model and serial number.
2
Only spare parts supplied or specified by Bibby
Sterilin Ltd. or its agents should be used. Fitting
of non-approved parts may affect the
performance and safety features designed into
the instrument.
If in any doubt, please contact the Technical
Service Department of Bibby Sterilin Ltd. or the
point of sale.
Bibby Sterilin Ltd
Stone
Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
E-mail equipment@bibby-sterilin.com
www.bibby-sterilin.com
Warranty
Bibby Sterilin Ltd warrants this instrument to be
free from defects in material and workmanship,
when used under normal laboratory conditions,
for a period of two (2) years. In the event of a
justified claim Bibby Sterilin will replace any
defective component or replace the unit free of
charge.
This warranty does NOT apply if damage is
caused by fire, accident, misuse, neglect,
incorrect adjustment or repair, damage caused by
incorrect installation, adaptation, modification,
fitting of non approved parts or repair by
unauthorised personnel.
Catalogue
Number
SA8/1
SA7013
SR2