Installation Considerations - Renegade RXA 100 B Manual De Uso

ENG
User's Manual
CAUTION:
No general operating permit is available for this soundsystem.
It's up to the buyer and owner of the vehicle to ensure the roadworthiness according to your
national traffic regulations. We recommend if applicable to check the legal position regarding
the roadworthiness prior to the installation of the soundsystem.
SPECIFICATIONS
Operation Voltage:
Output Power:
THD:
S/N:
Frequency response:
Input Sensitivity:
CONTENT
Amplifier:
Loudspeaker:
Powercable:
AUX audiocable:
Mounting bracket:
Screwkit:
User's Manual:

INSTALLATION CONSIDERATIONS

Before beginning any installation, follow these simple rules:
1. For safety, disconnect the negative lead from the battery prior to beginning the installation.
2. For easier assembly, we suggest you run all wires prior to mounting your soundsystem in place.
3. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines,
vacuum lines or electrical wiring when working on the vehicle.
4. Never run wires underneath the vehicle.
5. Avoid running wires over or through sharp edges.
MOUNTING
1. Determine where the soundsystem will be mounted. Ensure that neither the steerability, the brakes nor any
other functions of the vehicle are impaired by the installation of the soundsystem.
Choose an appropriate and splash water protected location for the amplifier (e.g. under the seating bench).
2. Be sure to observe proper polarity when connecting the wires from the battery to the amplifier.
3. Do not overtighten the screws.
Check the following pages for further information.
10~16V DC
2 x 25 W/RMS
2 x 50 W/MAX
<0.1%
>50dB
20Hz-20kHz
150mV
1x
2x
1x
1x
2x
1x
1x