Before Getting Started; Removing The Battery Fuse; Operation; Setting The Date / Time (Fig. C) - Silvercrest SSOT 6 A1 Instrucciones De Uso

Before getting started / Operation

Before getting started

Removing the battery fuse

Push the battery compartment lid
Pull the tab of the protective fi lm out of the battery
compartment.
Push the battery compartment lid
compartment until it clicks into place (Fig. A).
– When it is switched on, an internal alignment and a
self-test of the LC display are carried out.
– To verify that all of the bars of the numbers are being
managed correctly, when you switch on check the
display of the LC display
against the example (Fig. B).

Operation

Setting the date / time (Fig. C)

You only have to set the date and time when you operate
the appliance for the fi rst time and after you change the
battery.
1. Press and hold the "MEM / SET" button
two seconds in standard mode. An acoustic signal
will sound. The device is now in set-up mode.
2. Press the "MEM / SET" button
the 12-hour or 24-hour format.
downwards.
10
onto the battery
10
on your appliance
5
to choose between
1
down for
1
GB/MT 107