Insert Tools, Accessories - Hilti SFC22-A Manual De Instrucciones

The working environment may be as follows: construction site,
workshop, renovation, conversion or new construction.
2.2 Chuck
Keyless chuck
en
2.3 Switches
Control switch with electronic speed control
2-speed gear selector switch
Forward / reverse selector switch with safety lock
Torque and drilling mode setting ring
2.4 Grips
Vibration-absorbing grip
2.5 Lubrication
Grease lubrication
2.6 The items supplied include (toolbox versions):
1 Power tool
1 Operating instructions
1 Hilti toolbox
2.7 The items supplied include (cardboard box versions):
1 Power tool
1 Operating instructions
2.8 Additional items required for operating the tool
B 22/1.6 Li­Ion, B 22/2.6 Li­Ion, B 22⁄3.3 Li­Ion, B 14/1.6 Li­Ion
or B 14/3.3 Li­Ion battery with C4⁄36­90, C4⁄36­350, C 4/36,
C 4/36­ACS or C 4/36­ACS TPS charger.
2.9 Li-ion battery charge status and overheating indicator
LEDs light con-
stantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
-
2.10 Overload and overheating protection
The power tool is equipped with an electronic protection system
to prevent overloading and overheating. The power tool switches
itself off automatically in the event of overloading and overheating.
After releasing the control switch, the power tool may not restart
immediately when the switch is pressed again (while the power
tool is cooling down).

3 Insert tools, accessories

Designation
Bit holder
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Battery
Battery
Battery
Battery
18
Printed: 05.09.2013 | Doc-Nr: PUB / 5071588 / 000 / 01
LEDs blink
-
-
-
-
LED 1
LED 1
Short designation
S-BH 50
C 4/36
C 4/36­ACS
C 4/36-ACS TPS
C 4/36­90
C 4/36­350
B 22/1.6 Li­Ion
B 22/2.6 Li­Ion
B 22/3.3 Li­Ion
B 14/1.6 Li­Ion
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Battery overheated