MELICONI HP COMFORT Instrucciones De Uso página 18

If the headphones do not produce any sound, or if the audio signal is distorted or is presumed to come from another
source, carry out the following procedure:
1. Place the headphones onto the base
2. Make sure that the AC adaptor is fully inserted into the power outlet and that the cable is properly connected to the
13
connector from the base (DC IN).
3. Make sure you use fully charged batteries. If necessary, recharge them.
4. Make sure the TV or audio equipment is turned on and plays an audio signal.
5. Remove the headphones from the base and make sure that the RED SIGNAL light
constantly on when there is an incoming audio signal. If necessary, increase the volume of the audio source.
6. Move closer to the base, turn on the headset and check the RED
7. On the headset, check that the GREEN led is on
7
volume control
wait.
8. If the problem persists, turn the headphones off, and using the selector
2-3) and repeat the procedure from point 6 onwards.
• read this instruction manual carefully, as it will help you resolve most problems.
• consult our website: www.meliconi.com
2 YEAR WARRANTY
The manufacturer, Meliconi S.p.A., hereby declares that the radio device, HP COMFORT headphones is
compliant with Directive 2014/53/EU (RED). The full text of the EU Declaration of Compliance
16
Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 16 Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 16
Troubleshooting
(wheel) to adjust the sound level; if necessary, press the AUTO TUNE button for a moment and
If you have any problems with or questions about HP COMFORT:
In any eventuality, you can send an e-mail to: info@meliconi.com
SIMPLIFIED EU DECLARATION OF COMPLIANCE
is available at the following internet address:
www.meliconi.com/doc/hpcomfort
2
(POWER) led lights up.
3
. If there is no audio in the headphones, use the headphone
14 on the base, try to change channels (1-
Helpline
10 on the base remains
03/08/18 14:35 03/08/18 14:35