Dometic PERFECTVIEW M9LQ Instrucciones De Montaje página 19

M9LQ
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions or
damage to components.
Correct installation of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cable:
• To prevent damage to the cables, when laying them ensure that there is always a sufficient
interval to vehicle components which can become hot (lights, heaters, ventilators etc.).
• Make sure when laying the cable (fig. 3, page 4), that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d, page 8)
➤ Lay the monitor cable on the dashboard.
➤ Insert the plug (2) of the monitor cable in the socket (3) of the connection cable (4) and secure
them both.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (9) to terminal 15 (ignition).
– Connect the black cable (11) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the brown cable (10)
to the positive cable of the reversing light.
I
NOTE
If voltage is present in the brown cable (10), the reversing camera will be activated
automatically. The reversing camera has priority.
EN
Installing the LCD monitor
19