Alpina BT 48 Li 2.0 Manual De Instrucciones página 47

• The disconnection from line voltage
is made by pulling the mains plug.
• The socket outlet must be located close to
the machine and be easily accessible.
CHARGING PROCEDURE
NOTE The battery is not shipped fully charged.
It is recommended to fully charge before use to
ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a
memory and may be charged at any time
1. Plug the charger into an AC power outlet..
2.Insert the battery pack (1) into the charger (2).
CG 48 Li - CG 48 Li 60
This is a diagnostic charger. The Charger
LED Lights (3) will illuminate in specific order
to communicate the current battery status.
They are as follows:
CG 48 Li - CG 48 Li 60:
DESCRIPTION
Battery is charging
Fully charged
Battery is too warm
(remove for approx. 30
min. to allow to cool)
No battery present
Defective battery
(remove and replace
with new battery)
CGF 48 Li:
DESCRIPTION
Battery is charging
CGF 48 Li
LED STATUS
☼ Green blinking
● Green
● Red
○ OFF
☼ Red blinking
LED STATUS
☼ Green ● Red
blinking
Fully charged
Battery is too warm
(remove for approx. 30
min. to allow to cool)
No battery present
Defective battery
(remove and replace
with new battery)
False Defect Note:
When the battery is inserted into the charger,
and the status LED flashes, remove the
battery from the charger for 1 minute, then
reinsert. If the status LED indicates
normal than the battery pack is good. If
the status LED is still blinking, remove
the battery pack and unplug the
charger. Wait 1 minute and plug the charger
back inand reinsert the battery pack. If the
status LED indicates normal than the battery
pack is good. If the status LED is still blinking
then the battery pack is defective and needs
to be replaced.
NOTE When the red indictor flickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull out the
AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the
battery again. If the indictor shows charging,
that means the battery is good. If not,
the battery needs to be changed.
CHECKING THE CHARGER
If the battery pack does not charge properly::
• Check the current at the power
outlet with another tool. Make sure
that the outlet is not turned off.
• Check that the charger contacts have not
been shorted by debris or foreign material.
• If the surrounding air temperature is not
normal room temperature, move the charger
and battery pack to a location where the
temperature is between 7 ˚C and 40˚C .
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the
charger from approximately 30 minutes.
EN - 4
● Green ● Red
Red
○ OFF ☼
blinking
○ OFF ● Red
Green Red
☼ ☼
blinking blinking