Positive Connection; Switching Positive; Fuse; Negative (Ground) Connection - Blaupunkt IVSC-3302 Instrucciones De Manejo E Instalación

Note:
Before connecting the monitors to
your signal controller, check that the
+/- and switching positive connec-
tions are working properly.

Positive connection

Connect the fuse holder (1A fuse) to
protect the positive cable (permanent
(1), see Fig. 1). The fuse holder should
be connected to the positive terminal at
a distance of max. 30 cm from the vehi-
cle battery (if necessary, drill a hole in
the bulkhead and use the appropriate
cable grommets).

Switching positive

Connect the switching positive cable (2)
(see Fig. 1) to the switching positive
output (ignition
vice (e.g. car radio or navigation device).
If connecting to terminal 15 of the vehi-
cle, protect the switching positive cable
(2) by installing a fuse holder (1A fuse)
at a maximum distance of 20 cm from
the point of connection.

Fuse

If the fuse needs to be replaced, never
bypass/bridge the fuse and never re-
place it with fuse types that are designed
for higher currents.

Negative (ground) connection

Attach the negative cable (1) (earth/
GND, (3), see Fig. 1) directly to the ve-
hicle body using a screw. Scratch the
surface down to the bare metal at the
point at which the ground is made.
) of the main de-
INSTALLATION
• If the installation requires holes to be
drilled or any other changes to be
made to the vehicle, please contact
a specialist workshop in your area.
13