Craftsman 536.888110 Operator's Manual página 30

[.,,."_o,,_ V_I Z IB]P'_"_
TRACTION DRIVE CABLE ADJUSTMENT
1. 6. Push the bottom of the traction
2,
3.
Run the engine until the fuel tank is
empty and the engine stops.
Stand the snow thrower up on the
front end of the auger housing.
Loosen the bolts on each side of
the bottom panel (see Figure 39).
Bolt Bottom Panel
N
Figure 39
9,
10.
drive cable through the cable ad-
justment bracket until the "Z"
hook can be removed.
Remove the "Z" hook from the
cable adjustment bracket. Move
the "Z" hook down to the next ad-
justment hole.
Pull the traction drive cable up
through the cable adjustment
bracket.
Put the cable boot over the cable
adjustment bracket.
To check the adjustment, depress
the drive lever and check the length
of one of the drive springs. In cor-
rect adjustment, the length of the
drive spring is:
minimum 3" (76 mm.)
maximum 3-3/8" (85 mm.)
(see Figure 41),
Remove the bottom panel,
Slide the cable boot off the cable
adjustment bracket (see
Figure 40),
¢_ so_
Traction f i'_f/ii
Drive Cable_i
/
Cable Boot_X-(i J
_/ "Z" Hook
Cable Adjustment //
Bracket Figure 40
Drive S e 41
F 0410110L 30