Connection Scheme; Operating Instructions - REV Ritter 880 Instrucciones De Montaje

GB
Installation instuction
1. Connection to a transformer 8V~/1A or battery operation
• Disconnect the bell transformer of the mains (only when operated
with the transformer).
• Remove the front cover.
• Introduce cables and fix the lower part of the chime housing.
• Connect the wires according to the drawing either as transformer or
battery operation.
• Insert 2x 1,5V AA Mignon batteries or rechargeable batteries
(always necessary).
• Cover has to be put properly on the housing.
• Turn on the fuse again.
• Choose melody with button on the right of the terminals.
• Sound distortion and a low volume are signs that the battery is
weakening. In that case the battery has to be replaced.
Caution: The installation can only be done when the chime is not
connected. The relevant guidelines have to be followed.

2. Connection scheme:

230V~ power network
transformer
8V~
bell button
230V~ power network
transformer
8V~
bell button
6
chime
8V~
Terminal clip A
Terminal clip B
Terminal clip1
Terminal clip 2
AA
AA
2x 1,5V AA
8V~ chime
Terminal clip A
Terminal clip B
Terminal clip1
Terminal clip 2
AA
AA
2x 1,5V AA
chime
Terminal clip A
Terminal clip B
Terminal clip1
bell button
Terminal clip 2
AA
AA
2x 1,5V AA
chime
Terminal clip A
Terminal clip B
Terminal clip1
Terminal clip 2
bell button
AA
AA
2x 1,5V AA