Midwest Critter Nation 162 Manual De Instrucciones página 4

9. Locate the remaining Door Panel (A) and insert the pegs
into the outer-most holes of the Base Assembly. The
Door Panel should be inserted on the side of the stand
that has the two locking casters. Be sure the door
locking knobs face outward.
Locate the Middle Floor Panel Grid (G) and insert the
10.
protruding wires into the corresponding holes of the
Door Panel. Orientate the panel so the opening is either
in the back-right or front left of the cage.
Locate the remaining Back Panel (B) and insert one peg
11.
in one of the back, outer-most holes. Be sure the
protruding rectangular openings are facing inward.
While slightly lifting the Middle Floor Panel Grid, swing
the other end of the back panel around, aligning the
protruding wires of the Grid with the holes in the Back
Panel. When they are all lined up and inserted, put the
peg in the outer-most hole.
Locate the remaining two Side Panels (C), two Swivel
12.
Locks (Q), and two Flat Head Screws (P). Using the
Phillips Head Screwdriver (R) and flat head screws
attach one Swivel Lock to each of the Side Panels. (Do
not tighten all the way).
13. Attach the Side Panels by inserting the pegs into the
holes between the Door and Back Panels. Be sure the
cut-outs on the bottom go around the protruding wires
of the Bottom Floor Panel Grid. Insert the protruding
tabs at the top of the panels into the protruding openings
in the Door and Back Panels to lock the panels together.
Locate the Top Panel Grid (D). Lay the Top Panel Grid
14.
on the top of the assembled Cage. Line up the panel
so the pegs in the corner line up with the openings in
the corners of the assembled cage. To secure the Top
Panel, swing the Swivel Lock around the wire of the Top
Panel till tight in place. It may be easier to open doors
and swing Swivel Lock from side of cage. Open the
doors by pinching the knobs on the doors together.
Once Swivel Lock is in place, tighten Flat Head Screw.
11
10
12
14
13
9
14