Blade Maintenance - Bosch AXT Rapid 180 Instrucciones De Servicio

EURO • BA F016 L69 923 • AXT RAPID 180/200 • GB • OSW 03.06
F 016 L69 923 - GB Seite 4 Mittwoch, 18. Juni 2003 2:57 14
Maintenance
Stop and remove plug from the power sup-
ply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged blade, loose fixings, and
worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (typ) from the
nameplate of the machine!

Blade Maintenance

E
Stop and remove plug from the power sup-
ply.
The blade has a double sided cutting edge.
When the cutting edges become blunt, the blade can
be turned over. When both sides are blunt replace
the blade.
Use the following procedure to remove, turnover or
replace the blade:
Unscrew securing knob 3 .
Remove cover 11 as shown in fig.
Wearing a pair of garden gloves (not supplied) turn
the blade 13 so that it aligns with the markings on
the reaction plate 17 .
Insert a screw driver into the hole 14 to lock the
drive.
Use the allen key 12 to remove the blade
bolt 16 , and the blade washer 15 .
Remove the blade 13 by lifting and sliding down-
wards as shown in fig.
Fit the blade, blade washer and the blade bolt.
Tighten the bolt firmly (tightening torque 12 Nm).
Ensure that the allen key 12 and screw driver are re-
moved, also ensure that the cover 11 and securing
knob 3 are fitted before attempting to turn the ma-
chine on.
15 • F 016 L69 923 • TMS • 13.06.03
E .
E
English - 4
Accessories
Blade................................................. F 016 800 164
Collection bag ................................... 2 605 411 073
Gloves............................................... 2 607 000 134
Protective goggles ............................ 2 607 990 041
Lubricant spray ................................. 1 609 200 399
After Shredding/Storage
Stop and remove plug from the power sup-
ply.
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all debris, especially from the
ventilation slots 5 .
Store the machine in a dry place. Do not place other
objects on top of the machine.
For additional security the switch can be padlocked
(padlock not supplied) as shown in fig. D .