Gewiss Chorus GW 10 798 Manual Del Usuario página 28

After the 8 channel EIB RF receiver - flush-mounted is set using ETS software, the front
button can be used to test EIB channel operations.
Turn the rotating switch to a value between 1 and 8 on the receiver and press the front
button. A command will be sent to the bus that identifies the linked EIB channel as shown
in the following charts. This function may be useful in testing correct device operations
and to find the EIB channels to be linked to RF commands during their configuration.
When the rotating switch is on 0, the front button does not run any function.
Rotating switch position
Concerned
communications object
RF-EIB
channel
configuration
sequence/
8/16 bit values
(1) The ON or OFF value depends on how the sensor alarm status was set (direct or
reverse) in the ETS configuration.
GENERAL DESCRIPTION
KNX/EIB channel test
1
n. 0
switching
to the concerned communications object
priority
control to the concerned communications object
dimmer
to the concerned communications object
shutters
to the concerned communications object
sensor
1
alarms to the concerned communications object
scene
to the concerned communications object
command
to the concerned communications object
2 3 4
n. 6 n.12 n. 18 n. 24 n.30 n. 36 n.42
Send "ON"
Send "override on"
Send "ON"
Send "move shutters down"
Send "ON/OFF"
Send "run scene A"
Send "value 1"
28
5 6 7 8