Parts Names And Handling Instructions; Control Panel; Safety Lock - Panasonic MX-ZX1800 Instrucciones De Funcionamiento

Parts Names and Handling Instructions

■ Wash all the detachable parts before using the appliance for the first time or when you have not used it
for a while. (P. GB22)
Cap
Lid
Lid unit
Lid gasket
Blender jug
Working capacity: 1800 mL
Jug gasket
Blade
Blender jug base
Motor housing

Control panel

Circuit breaker (Located on the bottom)
(P. GB25) (Reset)
Accessories
around the blender jug. It may block the view when using the tamper.
* Cold Insulation duration may vary by temperature of room and ingredients.
Jug base holder
(Use it to attach/remove the
blender jug base.)
Drip tray
Tamper
Use this drip tray when
Use it to circulate or mash
using the ice pack to
ingredients. (P. GB19)
collect water drops.
GB12
Handle
Power switch
(Located on the back)
Mains lead
Mains plug
Ice pack (Cool it in a freezer for over 4 hours)
Use this ice pack to keep your mixture
cool (approx.30 minutes*) while blending
and/or after blending by wrapping it
Cleaning brush
Menu label
Sticking position: Refer to the
directions on the "Menu label".
Control panel
Menu indicator
Auto menus
Juice
Smoothie
Puree
Soup
Grind
Stop/Start
Frozen
Speed
Shows blending speed by using
bars when operating manual
mode. Turn the dial to the left or
right to respectively adjust for a
lower or higher speed before
pressing the stop/start button.

Safety Lock

A safety interlock system was designed to prevent the motor from
turning on without the blender jug, or the blender jug is not properly
engaged or is tilted during use.
Do not defeat the safety pins in any way. Doing so will cause the
motor to turn on, possibly causing personal injury.
Manual mode
Pulse (for manual mode only)
Use this function for short
duration. It only operates
when "Pulse" is held down.
Dial
Adjusts time and speed.
Operating Time
Shows operating time when using an
auto menu by using bars that
decrease until completion. Turn the
dial left or right to respectively adjust
for a shorter or longer operating time
before pressing the stop/start button.
Safety lock pin
GB13