Vacuum Will Not Stop - Mvac M20 Manual De Instrucciones

PROBLEM

Vacuum will not stop

If in spite of these suggestions your vaccum unit is still not stopping,
contact your authorized service center.
TROUBLESHOOTING
POSSIBLE CAUSE
Hose improperly
inserted into
vacuum inlet
Defective on/off hose If the hose is properly
Low voltage wire not
connected properly
Troubleshooting
CORRECTIVE ACTION
Ensure that the hose end
is properly placed in the
vacuum inlet: the tab on
the hose should fit into
the slots on the inlet, to
ensure adequate contacts
for the hose switch to
function (see page 9).
placed in the vacuum
inlet, and the unit
continues running despite
the fact that the hose
switch is in the "off"
position, have the hose
checked by a service
center.
While vacuum is on,
unplug low voltage wires
from unit. If the vacuum
stops, there's a faulty low
voltage wire. Contact your
fitter or authorized service
center.
17