Hose Hook-Up & Inlets - Mvac M20 Manual De Instrucciones

BEFORE OPERATING YOUR CENTRAL VACUUM...
Please verify that it is properly connected to the piping system, and to a
grounded electrical outlet, and that the low voltage wires are connected to the
unit (see pages 8 to 16). Then read the complete owner's manual and proceed
with a quick verification of your installation:
works properly.
check other inlets for leaks.
To start your central vacuum, simply insert the hose in the vacuum inlet
of your choice. Please ensure that the tab on the hose end is properly lined
up with the slot in the inlet opening (figure 4). If your hose handle has an
integrated on/off switch, simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it
may damage the inlet's rubber seal.
HOSE HOOK-UP & INLETS
figure 4
Operating Instructions
9