Metabo HPT C 12LCH Instrucciones De Manejo página 19

8. Crown molding cutting procedures
Fig. 28 shows two common crown molding types having angles of (θ) 38° and 45°.
For the typical crown molding fittings, see Fig. 29.
Walt
The table below shows the miter angle and the bevel angle settings that are ideal for the two crown
molding types.
NOTE:
For convenience, positive stops are provided for the miter setting (left and right 31.6°) positions.
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting side handle
a little to the right and left to stabilize the position and to properly align the miter angle scale and the tip
of the indicator before the operation starts.
For bevel cut setting
Move handle on bevel section to the left and check that the position is stable and that the bevel angle
scale and the tip of the indicator are properly aligned. Then tighten the clamp lever.
To process crown molding at
Type of
positions 1 and 4 in Fig. 29.
Crown
Molding
Miter Angle
Setting
45° Type
right 35.3°
( mark)
38° Type
right 31.6°
( mark)
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 29 (see Fig. 30; tilt the motor head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (A in Fig. 28) contacts the fence as indicated
in Fig. 32.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 29 (see Fig. 31; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (B in Fig. 28) contacts the fence as in Fig. 33.
A upper surface
Ceiling
B lower surface
Fig. 28
Bevel Angle
Setting
left 30°
( mark)
left 33.9°
( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Ceiling
Wall
Inside corner Outside corner
Fig. 29
To process crown molding at
positions 2 and 3 in Fig. 29.
Miter Angle Bevel Angle
Setting Setting
left 35.3° left 30°
( mark) ( mark)
left 31.6° left 33.9°
( mark) ( mark)
English
19