Settings (Introduction) - Esoteric D-02 Manual Del Usuario

1
Repeatedly press the MENU button to select
the menu item to be changed.
Each time you press the MENU button, the item shown on the
display changes as follows.
UPCONV>
DF>
CLK>
WOUT>
USB>
CH>
i_RC>
If no button is pressed for more than 10 seconds, the unit will
exit setup mode
< The SETUP button on the remote control unit of the P-02 can
also be used for this.
2
Use the VOLUME (–/+) buttons to select the
options within the menu item.
Individual menu functions are described on pages 12-17.
< The INPUT (</>) buttons on the remote control unit of the
optional P-02 can also be used for this function.
< Settings are stored even when power is turned off and the unit
is unplugged. If left unplugged for an extended period, the
settings may be lost.

Settings (introduction)

DIMMER>
FLaOFF>
DP>
XLR>
A_OUT>
RC>
Setting items and their explanations
UPCONV>** *
Upconversion setting
Sets the upconversion sampling frequency (see page 12).
DF>** *
Digital filter setting.
Sets the digital filter of the D/A converter (see page 12).
CLK>** *
CLOCK setting
Sets the synchronization with an external clock and clock output
settings sent to source devices that support word sync (see page
13).
WOUT>** *
Clock output frequency setting
Sets the clock frequency output when the clock setting is "W_
OUT", "W_IN", "10M_IN" or "MCK_IN" (see page 14).
USB>* **
USB input setting
Sets the mode when using USB input (see page 14).
CH>** *
Playback channel setting during i.LINK input
Sets the channel played back by this unit when using an i.LINK
input (see page 15).
i_RC>** *
i.LINK remote setting
Sets coordinated functions when multiple D-02 units are
connected by i.LINK cables (see page 15). This is typically used
for multi-channel SACD applications only.
RC>* **
REMOTE control setting
Sets remote control settings when using this unit simultaneously
with an Esoteric amplifier (see page 15).
A_OUT>* **
Analog output setting
Sets the analog output connector used (see page 15).
XLR>** *
XLR output setting
Sets the XLR output gain level (see page 16).
DP>** *
Display setting
Sets what is shown on the display (see page 16).
FLaOFF>* **
Automatic fluorescent display off setting
Sets the time until the display automatically turns off (see page
17).
DIMMER>* **
Dimmer setting
Sets the brightness of the display and indicators to one of four
levels (see page 17).
11 11