Settings 1; Upconversion Setting; Clock Setting - Esoteric Grandioso D1X Manual Del Usuario

Settings 1

Upconversion setting

UPC>***
When a PCM signal from a CD, for example, is input, you can use this
setting to upconvert that signal or convert it to a DSD signal .
This setting can be made for each input .
By default, the setting is ORG .
o DSD signals cannot be upconverted .
ORG
Upconversion will not occur .
o The input signal is sent as is to the D/A converter without being
upconverted .
2Fs
When PCM signals with frequencies of less than 88 .2 kHz are
input, they are upconverted before being converted from digital
to analog .
4Fs
When PCM signals with frequencies of less than 176 .4 kHz are
input, they are upconverted before being converted from digital
to analog .
8Fs
When PCM signals with frequencies of less than 352 .8 kHz are
input, they are upconverted before being converted from digital
to analog .
16Fs
When PCM signals with frequencies of less than 705 .6 kHz are
input, they are upconverted before being converted from digital
to analog .
DSD
Signals are converted to DSD before being converted from digital
to analog .
14

Clock setting

CLK>***
Use this to set synchronization with an external clock .
By default, the setting is OFF .
o Set this to OFF when connected to a source device, other than
USB input, that does not support clock synchronization .
OFF
Clock synchronization is not used . The unit will operate with the
clock of the input digital signal .
The built-in oscillator will be used with USB input .
The CLOCK indicator lights green .
SYNC
In this mode, the unit is synchronized with the 10MHz clock signal
input through its CLOCK 10MHz IN connector from a clock generator .
The CLOCK indicator lights blue . The CLOCK indicator blinks when
in the process of synchronizing or unable to synchronize .
o The audio source device must also be connected to the clock
generator and set to receive clock synchronization .
o The clock frequency that can be input is 10 MHz . The input
audio signal and the input clock signal must be synchronized .
o Be aware that during music playback, if the clock generator
is turned off or the BNC coaxial cable that is supplying the
10MHz clock signal is disconnected, causing the clock signal to
stop, a loud noise could be emitted from the speakers .