Packaging; Starting, Operation; Mechanical Connection - WIKA N-10 Manual De Instrucciones

5. For your safety / 6. Packaging / 7. Starting, operation
Consider the respective country specific regulations for installation and
operation in hazardous areas (e.g.: IEC 60079-14). If you do not observe
these stipulations, serious injuries and/or damage can occur.
Warning

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure transmitters; with flush version N-11 including pre-

assembled sealings and protection cap.
 Inspect the pressure transmitter for possible damage during transportation. Should
there be any obvious damage, inform the transport company and WIKA without delay.
 Keep the packaging, as it offers optimal protection during transportation (e.g. chan-
ging installation location, shipment for repair).
 Ensure that the pressure connection thread and the connection contacts will not be
damaged.
In order to protect the diaphragm, the pressure connection of the instrument N-11 is provided
with a special protection cap.
Remove this protection cap by hand only just before installing the pressure transmitter

in order to prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for

later storage or transport.
Mount the protection cap when removing and transporting the instrument.


7. Starting, operation

Required tools: wrench (flats 27), screw driver
6 WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio N-10, N-11
GB
7. Starting, operation
Diaphragm test for your safety
It is necessary that before starting the pressure transmitter you test the diaphragm visually, as
this is a safety-relevant component.
Pay attention to any liquid leaking out, for this points to a diaphragm

!
damage.
Check the diaphragm visually for any damage (N-11).

Warning
 Use the pressure transmitter only if the diaphragm is undamaged.
 Use the pressure transmitter only if it is in a faultless condition as far as the
safety-relevant features are concerned.

Mechanical connection

max.
50 Nm
Sealing
Protect the diaphragm against any contact with abrasive substances and

pressure peaks and do not touch it with tools. If you damage the diaphragm,
no intrinsic safety can be guaranteed (ATEX)!
Warning
 Ensure that under hazardous ennvironment the pressure transmitter is
mounted in a shielded section and protect it against shocks.
 Observe the technical data for the use of the pressure transmitter in connec-
tion with aggressive / corrosive media and for the avoidance of mechanical
hazards.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio N-10, N-11
Product label (example)
Generally the
serial number on
the product label Signal
applies. If there is
Power Supply
no serial number on
Product No.
P #
the product label, Serial No.
S #
the number on the
PIN assignment
hexagon will apply.
Coded manufacture date
GB
7