Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Contents / Inhalt / Contenu / Contenido
Contents
Page -18
WIKA Global
Page 68
Inhalt
Seite 19-4
WIKA Global
Seite 68
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio N-10, N-11
GB
D
GB
Contenu
Page 5-50
11. Déclaration de confeamité CE
WIKA Global
Contenido
Paginás 51-66
D
4. Función
E
F
1. Important details for your information
1. Important details for your information
F
Read these operating instructions before installing and starting the pressure transmitter. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications. If
questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com
The product data sheet is designated as PE 81.26
Contact WIKA for additional technical support (+49) 9372 / 132-295
If the serial number on the product label and/or the 2D code on the hexagon gets illegible (e.g.
by mechanical damage or repainting), the retraceability of the instrument is not possible any
more.
WIKA pressure transmitters are carefully designed and manufactured using state-of-the-art
Page 68
technology. Every component undergoes strict quality and environmental inspection before
assembly and each instrument is fully tested prior to shipment. Our environmental manage-
E
ment system is certified to DIN EN ISO 14001.
Use of the product in accordance with the intended use N-10, N-11:
Use the non-incendive pressure transmitter to transform the pressure into an electrical signal
in hazardous areas, where category 3G resp. 3D equipment is required.
Certificate ATEX:
Pressure transmitter for operation in hazardous areas
II 3G EEx nA II T6 and II 3D IP65 T80°C
Knowledge required: Install and start the pressure transmitter only if you are familiar with the
relevant regulations and directives of your country and if you have the qualification required.
You have to be acquainted with the rules and regulations on hazardous areas, measurement
and control technology and electric circuits, since this pressure transmitter is „electrical
equipment" as defined by EN 50178. Depending on the operating conditions of your applica-
tion you have to have the corresponding knowledge, e.g. of aggressive media.
Paginá 68
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio N-10, N-11
GB
Publicidad
Tabla de contenido
