Control And Programming - fluidra ASTRALPOOL Compact kit Manual De Instrucciones

HOW TO USE YOUR SPA
5.2. START-UP
Once activated, your spa will go into priming mode (Pr). Finalized priming mode, press the jet
buttons several times to ensure that none of the pumps contains air. The priming mode lasts
for at least 5 minutes. Press either the "Warm" or "Cool" button to exit the priming mode. On
completion of the priming mode, your spa will work in the standard mode (see the section Mode/
Prog).
Functions that require the use of a sequence of buttons may not be recorded if the combination of
buttons is pressed in quick succession.

5.3. CONTROL AND PROGRAMMING

Temperature control (80°F-104°F/26,0°C-40,0°C)
The screen displays the last recorded temperature of the water at all times.The temperature
displayed on the screen is only valid when the pump has stopped working for at least 2 minutes.
In order for the screen to display the programmed temperature, press "Warm" or "Cool" once
only. To change the programmed temperature, press one of the temperature buttons repeatedly
until the desired temperature is reached. The temperature of the spa will appear 3 seconds after
one of the above buttons has been released.
20 Compact Kit for private use - Operating Instructions
VL700S
VL700S
VL700S
AUX
AUX
Circulation Pump
Massage pump
Heater
Turbo-Blower Pump
Spotlight(s)
Circulation pump
2 Massage pump
Heater
Turbo-Blower Pump
Spotlight(s)
Circulation pump
3 Massage pump
Heater
Spotlight (s)
Auxiliary panel
Auxiliary panel
(3 Massage pump)