GE JBS03 Manual Del Usuario página 33

Problem
Excessive condensation
in the warming drawer
Food dries out in the
warming drawer
Oven temperature too
hot or too cold
Clock and timer do
not work
Display goes blank
Oven door is crooked
Oven makes
clicking noise
or letter" flash in
the display
Power outage
Display flashes
Unable to get the display
to show "SF"
Possible Causes
Liquid in warming drawer.
Uncovered foods.
Temperature setting too high.
Moisture escaping.
Oven thermostat
needs adjustment.
Plug on range is not completely
inserted in the electrical outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
Oven controls improperly set.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is turned off from
showing in the display.
The door is out of position.
This is the sound of the
heating element turning
off and on during
cooking functions.
You have a function error code.
If the function code repeats:
Power outage or surge.
Power failure.
Oven control pads were not
pressed properly.
What To Do
Remove liquid.
Cover food with lid or aluminum foil.
Reduce temperature setting.
Cover food with lid or aluminum foil.
See the Adjust the oven thermostat–Easy to do
yourself! section.
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Replace fuse or reset circuit breaker.
See the Using the clock and timer section.
Replace the fuse or reset the circuit breaker.
See the Using the clock and timer section.
Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the
door, push down on the high corner.
This is normal.
Press the CLEAR/OFF pad. Put the oven back
into operation.
Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
CLEAR/OFF pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Some models will automatically resume their setting once
the power is restored. On models with a clock, you must
reset the clock. If the oven was in use, you must reset it by
pressing the CLEAR/OFF pad, setting the clock and
resetting any cooking function.
Reset the clock.
The BAKE and BROIL HI/LO pads must be pressed at the
same time and held for 3 seconds.
GEAppliances.com
33