1
SD/MMC
CARD
6
POWER
CD-113DPR
These instructions are intended for users
without any specific technical knowledge .
Please read these instructions carefully prior
to operating the unit and keep them for later
reference .
1 Applications
The CD-113DPR is suitable for versatile PA
ap plications . It is able to replay standard
audio CDs and MP3 and WMA files from
CDs, USB flash drives* and memory cards*
(32 GB max .) .
An audio unit (e . g . radio, tape deck,
mixer) can be connected for recordings in
MP3 format on a memory card or on a USB
flash drive . In addition, titles can be copied
as follows:
CD USB flash drive
CD memory card
USB flash drive memory card
Memory card USB flash drive
* Note: Due to the large number of storage device
manufacturers and device drivers, it cannot be guar-
anteed that all storage media are compatible with
the CD-113DPR .
2 Safety Notes
This unit corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to
skilled personnel only . Inex-
pert handling or modification
of the unit may result in electric
shock .
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water, splash water
and high air humidity . The admissible ambi-
ent temperature range is 0 – 40 °C .
•
Do not place any vessel filled with liquid on
the unit, e . g . a drinking glass .
•
Do not operate the unit and immediately
disconnect the mains plug from the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
2
3
4
5
7
8
9
0
LINE OUTPUT
R
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket, always
seize the plug .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not correctly connected
or operated, or if it is not repaired in an
expert way .
If the unit is to be put out of oper-
ation definitively, take it to a local
recycling plant for a disposal which
is not harmful to the environment .
3 Setting Up and Connecting
the Player
The player is designed for installation into a
rack (482 mm / 19"); however, it can also be
placed as desired as a desktop unit . For rack
installation, 1 rack space (RS = 44 .45 mm) is
required .
Prior to making or changing any connections,
.
switch off the CD-113DPR and the units to
be connected .
1) Connect the outputs LINE OUTPUT – L =
left channel, R = right channel – via cables
with RCA connectors to the CD player in-
puts, e . g . on a mixer or amplifier .
2) Connect the mains cable provided to the
mains jack first and then to a mains socket
(230 V/ 50 Hz) .
4 Operation
Switch on the player with the POWER switch .
The display will show
First the player will read the CD . If no CD
has been inserted, the player will read the
USB flash drive . If no USB flash drive has been
connected, the player will read the memory
card . If no memory card has been inserted,
the display will show
CD-113DPR
AUX INPUT
PLAY MODE
L
R
L
AUTO PLAY
.
Welcome
.
NO DISC
IR
PROG
SKIP
STOP
PLAY/PAUSE
REV
CUE
FIND
FOLDER
REPEAT
REC/DEL
230 V~ /
50 Hz
NORMAL
RANDOM/
AUTO PLAY
FUSE
USE ONLY WITH A 250V FUSE
4.1 Remote control
1) To insert the batteries (2 × 1,5 V, size AAA),
remove the battery compartment cover on
the rear side of the remote control . Insert
the batteries as indicated in the battery
compartment . Close the compartment
with the cover .
If the remote control is not in use for a
longer period of time, remove the batter-
ies to prevent any damage due to battery
leakage .
2) When you press a button on the remote
control, always direct the remote control
towards the sensor "IR" . There must be
no obstacles between the remote control
and the sensor .
3) If the range of the remote control de-
creases, the batteries are discharged and
must be replaced .
Discharged batteries must not be
placed in the household waste; al-
ways take them to a special waste
disposal, e . g . collection container at
your retailer .
4.2 Replaying music titles
1) Insert a CD with the lettering facing up
into the slot until it is pulled in automat-
ically
and / or
connect a USB flash drive to the USB
port
or connect a hard disk (with indi-
vidual power supply, if required) to the
USB port
and / or
insert a memory card into the slot SD / MMC
CARD, the notched corner of the card
facing up . To remove the card, slightly
push it in to eject the card from the slot .
2) To start the replay, press the button PLAY/
PAUSE II .
3) All other operating options are listed in
the table on page 9 . After operation,
switch off the unit with the POWER switch .
EJECT
REC
LEVEL
FUNC
7