Tabla de contenido
Publicidad
1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
•
Damage caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
•
Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
•
Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
•
Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
•
An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
•
Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
•
Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD TV
• easy installation
• in accordance with VESA standard 75/100mm
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2 and 3 of this manual.
A
5mm Allen key (1x)
M4 x 13mm screw (4x)
B
C
M4 x 10mm screw (4x)
D
M5 x 13mm screw (4x)
Concrete or Brick Support
•
Choose an installation spot able to support the weight of the bracket and the screen.
•
Use the bracket as a template to mark the hole locations. Check for electric lines or pipes.
Make sure the holes are level.
•
Drill the holes (± 60mm deep) using a power drill and a 10mm masonry bit. Insert a nylon
plug (G) in each hole.
•
Fix the bracket to the wall using all two lag bolts (F).
Wooden Support
•
Choose an installation spot able to support the weight of the bracket and the screen. It is
important that the bracket be mounted on beams and not simply on a panel.
•
Use the bracket as a template to mark the hole locations. Check for electric lines or pipes, or
metal studs in wood battens. Make sure the holes are level.
•
Drill the holes (± 60mm deep) using a power drill and a 3mm wood bit.
•
Fix the bracket to the wall using all two lag bolts (F).
12/05/2011
WB008
User manual
E
M5 x 10mm screw (4x)
M5 x 50mm lag bolt (2x)
F
G
Ø 8 x 36mm concrete plugs (2x)
H
Phillips screwdriver (1x)
4
©Velleman nv
Publicidad
Tabla de contenido
