Safety Instructions - Velleman WB061 Manual Del Usuario

1.

Safety Instructions

 Read the entire instruction manual before you start installation and assembly.
 Do not begin the installation until you have read and understood the instructions and warnings contained in
this installation sheet.
 If you have any questions regarding any of the instructions or warnings, please contact your local
distributor.
 This mounting bracket was designed to be installed and utilized only as specified in this manual.
 Improper installation of this product may cause damage or serious injury.
 This product should only be installed by someone of good mechanical ability, with basic building
experiences and fully understanding of this manual.
 Make sure that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
 Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
 Tighten screws firmly, but do not overtighten.
 Overtightening can damage the items, greatly reducing their holding power.
 This product is intended for indoor use only.
 Using this product outdoors could lead to product failure and personal injury.
2. Component Checklist – Important
See images.
 Ensure that you have received all parts according to the component checklist prior to installing. If any parts
are missing or faulty, contact your local distributor for a replacement.
 Mounting hardware not included.
3. Mounting
See images.
3.1 Wood stud wall mounting
 Make sure that the mounting screws are anchored in the centre of the studs.
 The use of a stud finder is highly recommended.
 Installers are responsible for providing hardware for other types of mounting situations.
 The installer must verify that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
3.2 Solid brick and concrete mounting
 Mark the exact location of mounting holes.
 Drill pilot holes.
 Screw the wall mount onto the wall.
 Slide the L-shaped holder along the wall plate rail until the hole in the holder is aligned with the last hole
but one in the wall plate.
3.3 Installing the VESA plate.
 Screw the VESA plate onto the TV.
 Tighten all screws but do not overtighten.
3.4 Hanging the TV onto the wall plate
 Carefully lift your TV and hook the VESA plate onto the mounted head.
 Insert two screws in the mounting holes.
 Tighten all screws using the allen key.
3.5 Cable management
 Connect the cables to your TV and run them through the wire saddle. Note: leave slack in cables to allow
for arm movement.
V. 04 – 25/09/2019
WB061
USER MANUAL
8 ©Velleman nv