Placement; Supply Line Assembly; Maintenance; Cartridge Replacement - Westinghouse QL292 Manual Del Usuario

Installation (continued)

PLACEMENT

1 . Move the assembled unit to its final location. Final hook up of the supply lines and drain system can now be completed.
2 . Once the sink is in place, use a carpenter's level to check the horizontal and vertical alignment of the utility sink. Adjust the leveling
feet as needed so that the unitlity sink is level and does not wobble .
SUPPLY LINES (NOT INCLUDED)
The supply lines that attach the faucet to the household
water system, are not supplied with this unit . They need to be
purchased separately .
Follow the manufacturers instructions for proper installation of
the supply lines .

Maintenance

CARTRIDGE REPLACEMENT

1 . Turn off the water supply to the faucet at the nearest
shut-off valve .
2 . Remove water indicator and make note of its color
orientation .
3 . Unscrew the screw using the hex key .
4 . Remove the handle .
5 . Unscrew the cartridge nut .
6 . Remove the old cartridge .
7 . Insert the new replacement cartridge .
8 . Install the cartridge nut . Do not over-tighten .
9 . Install the cap . Do not over-tighten .
10 . Install the handle and secure it with the screw .
11 . Insert the plastic indicator back into the handle with the
colors oriented as previously noted . Red is normally on
the left .
QL292
Cartridge
Faucet body
10
Water indicator
Screw
Cap
Nut
Handle