Publicidad
During operation, water and gas are leaking
through the outlet — pressure-relief valve is
engaged.
1. The siphon was overfilled.
2. Too many chargers were used.
During operation, gas is leaking between the
bottle and the head.
1. The head was not tightened securely.
2. Riser tube with gasket was not used.
3. The gasket has been damaged.
4. The bottle has been damaged on the upper
47080601_SMC_GA_kurz.indb 12
"Release the pressure" and refill the
siphon.
Observe the maximum filling amounts.
Ensure the measuring tube is fully
inserted before filling.
Pay attention to the maximum number
of iSi soda chargers to be used indicated
in the Siphon Data.
Tighten the head onto the bottle
by hand as per the instructions.
"Release the pressure" and insert the
riser tube in the bottle.
"Release the pressure." The riser tube
with gasket needs to be replaced and
is available as an original iSi spare part.
edge.
"Release the pressure." Send the siphon
to iSi or a service center.
12
08.11.18 15:00
Publicidad
