FRIGOGLASS ICOOL-40 Manual De Usario página 11

b. Always ensure that your merchandiser is installed on a stable surface/floor and is properly
levelled. The cooler must be leveled through proper adjustment of the leveling feet in all
installations. It must be ensured that the cooler does not exhibit any inclination towards its front
side and/or its lateral sides, after adjustment. It must be ensured that the cooler does not exhibit
any inclination towards its front side and/or its lateral sides, after adjustment. The use of a spirit
level is highly advisable to check leveling. Verify that the cooler sits firmly on the leveling feet.
The front cooler wheels (if available) should be able to rotate by hand after cooler installation
and adjustment. There are 2 adjustable feet for all models at the front under the chassis apart
from ICOOL-1300 HD which has 3 adjustable feet. The level foot at the middle of the cooler
must be adjusted in such a way that the lower edges of the internal cabin are aligned. The below
given check points must be on the same line.
There are 2 additional adjustable feet for ICOOL-40 & 150 models at the back under the chassis. Take
necessary precautions if lifting is needed during installation. Keep unauthorised people away from the
cooler until installation is completed.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm at the back. To make that possible, please turn the back spacer
as shown below.
e. Do not place anything on top of the cooler.
Note: Relocation of the ICM inside the outlet
a. Empty the ICM and unplug from mains supply.
b. Fully extract the levelling feet.
c. Move the unit to the desired location with the assistance of another person.
Check
points
Level foot at
the middle
Rotate back
spacer
ENG
11