After Use - Profi Care PC-IPL 3024 Manual De Instrucciones

CAUTION:
• This appliance should only be used with the power
adapter unit (included). Do not use it for other
appliances.
• Only use a 12 V power adapter unit (
A different power adapter unit may damage the
appliance.
4. Press the button to switch the appliance on.
- The cooling fan of the appliance will start.
- The indicator lamp of level display 1 is lit.
- And the indicator lamp START switches from red to
green after approx. 1 second. The appliance is now
ready for use.
5. To change the intensity level, press the
repeatedly. The corresponding indicator lamp of the level
display is lit.
Intensity level
The intensity level determines the intensity of the
emitted light flash. There are 5 levels.
1 = lowest level, 5 = highest level
The indicator lamp next to the level display shows the
intensity level that has been selected. With a higher
intensity level the hair removal result will improve, but
also the risk of possible side effects and complications
will increase.
Do not increase the intensity level within a session.
Symptoms may only occur after a couple of hours,
even if you do not experience any of them at first.
6. Place the skin contact surface onto the skin location.
Make sure that the skin location is even and flat, and
that the skin contact surface makes full contact with the
skin.
7. Once the skin contact surface rests completely on the
skin, the indicator lamp START will start flashing. The
appliance is now ready to emit a light flash.
PC-IPL3024_IM
NOTE:
The indicator lamp START only starts flashing when
the skin contact surface fully rests on the skin.
8. Press the release button for the light flash. The ap-
).
pliance will emit a light flash and you will hear a short
popping sound. This is normal for the appliance. At
the same time you may experience a mild, warm and
tingling feeling.
9. After the appliance has emitted a light flash it will power
up for the next light flash. This may take a few seconds.
10. Place the skin contact surface onto the next skin loca-
tion. Make sure to irradiate the same skin location only
once per session.
11. Press the release button for the light flash.
button
12. Proceed as described from point 6.
WARNING:
Immediately stop the usage if your skin forms blisters
or starts to burn!
NOTE:
The appliance turns off automatically after 10 minutes.
1. Turn off the appliance when the session is done. To do
this, press and hold the
Remember the last selected intensity level. The appli-
ance generally starts with the lowest intensity level the
next time you turn it on.
2. Disconnect both the power adapter from the socket and
the power plug from the appliance.
3. Clean the appliance and especially the skin support
surface after each session. (See chapter "Cleaning")

After Use

button for about 3 seconds.
30.04.18
89